What's Included in the Solar Well Pump kit:

- 24 Volt DC Solar Well pump, measuring 2 7/8" diameter and 16" in height.  Body is constructed of 304 Stainless Steel with a cast Stainless Steal 3/4" FNPT outlet.  Maximum lift capability on this pump is 100 meters!  

- MPPT Solar Water Pump controller.  Input voltage requirements are 24-50 VDC and a minimum of 320 watts of directly connected PV Solar Panels (not included - can provide excellent source!) 

- 3/4" NPT Stainless Steel to 1" ID hose barb adapter and stainless steel hose clamp. 

- Spare pump dive assembly.  New helical rotor and corresponding polyurethane bushing. 

- 2 float switches.  One is to be used down the well to prevent dry run operation.  The second is to place on the top of a destination holding tank to automatically shut off the pump when tank is full.  Neither is required to be used, but included in kit.  

- Durable heat shrink for electrical splices on downhole wire, terminal connectors for control box connections, pipe sealant tape and electrical tape.  

-  Stainless steel carabiner (hook connections) for attaching a recovery line.   

PUMP IN EMERGENCY SITUATIONS WHEN NO SUNLIGHT AVAILABLE!

120 AC to 36 Volt DC 1000W power supply in weather resistant housing

Comes complete with 3' AC power cord, and 3' output MC4 cables. 

Just unplug your solar panels from MC4 connections on the bottom of controller, and plug in Inverter.  You can now pump from generators, or standard AC power for emergencies!  

With any solar pump, the pump curve may vary depending on input.  I have created this pump curve myself, based on my experiences. Maximum output is approximately 8.2-8.3 gpm, at close to surface level, with 500 watts of input power.  When increasing to depths past 200 feet, it is highly advisable to increase wattage input up to 750 W or greater.